Start-Up; Connecting The Power And Signal Cables - Siemens SCD 19101 D Betriebsanleitung

09.08
4

Start-up

Caution
!
In order to ensure safe operation of the equipment, close attention must be paid to
the information contained in this Instruction Manual as well as the warnings in
Section 2 "Safety precautions".
Caution
Information for end customer
None of the settings must be changed on site by the user, otherwise the guarantee
is canceled. This also applies to settings made using the SCD 19101 D/DT keys.
These are therefore locked for certain applications. If settings have to be changed,
please contact the responsible servicing department.
The display is designed for individual connection to a graphics card with a power
supply of 100 or 240 Volt (TN-S system with PE conductor).
If the display is to be used in a sequence of several displays, or if it is not exactly
known whether the graphics card standard can be output by the display, refer to
Section 5.1 "Connecting the flat panel display".
In order to start the unit properly, the following steps should be carried out in the
given sequence.
4.1

Connecting the power and signal cables

Caution
Use a power cable with PE conductor and angled appliance plug corresponding to
the safety requirements of the respective country of use. If necessary, safe
disconnection from the power supply is achieved by removing the mains plug from
the mains socket.
The power supply and signal connections are located on the rear of the color flat
panel display.
• Mains connection: Insert the appliance plug of the mains cable into the power
supply socket (the green operation LED flashes slowly).
• 15-pin Sub-D connector: The flat panel display can be connected to the
computer system using the Sub-D connector. The display is adapted using an
OSD menu.
• DVI connection: The connection to the computer can also be made via the
digital single link or via the analog channel of the DVI connection. The picture
quality, noise immunity and radiated interference of the complete system
depend on the cable quality and length.
• Touch screen connection: The connection of the Touch Screen is via a cable
with USB-connector. The cable is fix connected to the monitor.
Hochauflösendes 19" Color Flat Panel Display SCD 19101 D/DT
A5E00316182-002
instruction manual
33