Safety Instructions; Product Description - CONDTROL NEO G220 Set Bedienungsanleitung

CROSS
CONDTROL NEO G220 Set
EN
LINE LASER

SAFETY INSTRUCTIONS

Attention! This user manual is an essential part of this product.
The user manual should be read carefully before you use the product
for the first time. If the product is given to someone for temporary
use, be sure to enclose user manual to it.
- Do not misuse the product
- Do not remove warning signs and protect them from abrasion,
because they contain information about safe operation of the
product.
Laser radiation!
Do not stare into beam
Class 2 laser
<1 mW 532nm
IEC 60825-1: 2007-03
-Do not look into the laser beam or its reflection, with unprotected
eye or through an optical instrument. Do not point the laser beam at
people or animals without the need. You can dazzle them.
-To protect your eyes close them or look aside.
- Always install the product in such a way, so that laser line is below
or above eye level.
- Do not let unauthorized people enter the zone of product operation.
- Store the product beyond reach of children and unauthorized
people.
- It is prohibited to disassemble or repair the product yourself. Entrust
product repair to qualified personnel and use original spare parts
only.
- Do not use the product in explosive environment, close to flammable
materials.
- Laser intensive glasses are used for better recognition of the laser
beam, do not use them for other purposes. Laser glasses do not
protect from laser radiation as well as ultraviolet radiation and reduce
color perception.
4
user manual
Laser radiation!
Do not stare into beam
Class 2 laser
<1 mW 630-670nm
IEC 60825-1: 2007-03
CROSS
CONDTROL NEO G220 Set
EN
LINE LASER
- Avoid heating the batteries to avoid the risk of explosion and
electrolyte leakage. In case of liquid contact with skin, wash it
immediately with soap and water. In case of contact with eyes, flush
with clean water during 10 minutes and consult the doctor.

PRODUCT DESCRIPTION

Cross line laser NEO G220 CONDTROL is intended to build and check
vertical and horizontal planes and lines, as well as up and down laser
dots (zenith and nadir).
The product has 2 operating modes:
- locked compensator, to build inclined planes and lines;
- automatic levelling to project horizontal and vertical planes
and lines. Levelling function allows to automatically compensate
irregularities within self-levelling range of ±4,5°.
Pulse mode allows using laser receiver to increase working range of
the instrument or to work when laser is hard to be defined in bright
lighting conditions.
user manual
5