4.5
Installing motor
[1]
•
Disassemble the bed according to the
instructions in §4.4, up to step [11], to
create some space to work.
•
Use the handset to raise the frame cross.
4.6
Installing trapeze handle
37
•
Place lifting strap (34) with anti-slip
holder (37) on lifting pole (2).
•
Adjust the length of belt (35) by sliding
the belt through the buckle (36).
•
Put the remaining belt end through the
belt loop.
•
Make sure that the belt is well tightened.
[2]
•
Install the motor of the leg section
according to the mounting instructions
included in the box of the actuator.
•
Assemble the bed according to the
instructions in §4.3.
2
34
35
2.
Lifting pole
34. Lifting strap
36
35. Belt
36. Buckle
37. Anti-slip holder (elastic)
Installation manual
- 19 -
Assembly and disassembly
33
EN
Illico
NL
2018-07
PL
CS