Vermeiren illico Installationsanleitung Seite 17

21
[5]
•
While resting on the roller wheels, lay the
leg section with the frame cut-out (20)
over the rollers (19) of the undercarriage.
If the rollers (19) do not fall in the
frame cut-outs (20) of the leg section,
adjust the height of the cross
according to step 3 and try again.
•
If applicable, connect the motor of the leg
section to the control box, see §4.2.
32
[7]
•
Lift the head-section end and place it
horizontally. Safety guide (31) will get
caught by locking pin (32) of the
undercarriage preventing
section from lowering again.
•
Connect the motor of the head section,
see §4.2.
20
19
21
[6]
•
Take the head section and roll it to the
undercarriage, on the side of the control
box.
•
While resting on the roller wheels, lay the
head section on supports (21) of the
undercarriage, see previous picture.
If the rotation pins of connection (22)
do not fit in the supports (21), adjust
the height of the cross according to
step 3 and try again.
31
D
[8]
•
Lift the leg-section end a bit and move it
towards the head section.
CAUTION
the head
If the leg section has a motor, make sure
that it does not hit the bend frame tube of the
undercarriage at point D. For this reason,
keep the leg-rest end in low position till the
motor has passed the bend frame tube.
Installation manual
- 13 -
Illico
2018-07
Assembly and disassembly
22
Risk of damage
EN
NL
PL
CS