Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
MSK2000
Installation
4.3 Mounting the magnetic sensor
Alignment of the magnetic sensor
NOTICE
` Take care that the magnetic sensor is aligned correctly in order to
1. Mount magnetic strip (see chapter 4.2).
2. Fasten the magnetic sensor via the thru-holes (2x ø3.5 mm) on an
LINEAR application:
MSK2000 with MB2000:
Fig. 6: Definition of the counting direction with magnetic strip and
assemblage sensor / magnetic ring, gap measure, tolerances
MSK2000 · Date 07.02.2018 · Art. No. 81962 · Mod. status 44/18
ensure optimum sensing (see
even work surface (for the fastening dimensions refer to the Data
Sheet). We recommend to use the enclosed fixing screws and washer
springs (fastening torque = 0.25 Nm).
±3°
Fig.
6).
Active side magnetic strip
1
Counting direction signal A
2
±3°
before B
Direction of outgoing cable
3
Admissible deviation of
4
strip/sensor 1 ... 10 mm
Maximum alignment error
5
Admissable deviation middle
6
of tape/sensor
tape 10 mm = ±2 mm
tape 20 mm = ±5 mm
English
21
Werbung
Kapitel
Inhaltsverzeichnis
