Commissioning; Joining Magnetic Strips Together - Siko MSK2000 Originalmontageanleitung

MSK2000
24

Commissioning

Strand cross sections of lines 0.14 ... 0.5 mm².
5 Commissioning
Following correct mounting and wiring you can put the measuring system
into operation by switching on operating voltage.

6 Joining magnetic strips together

For some applications it may be necessary to extend the magnetic strip.
The magnetic strip can be cut and rejoined using standard tools.
But however carefully this is done the accuracy of the strip at the join will
be impaired (error of at least 0.1 ... 0.2 mm).
The following tools / accessories are required
• magnet magnifier, magnetic foil or metal dust
• rule or suitable tool
• compass needle
    
Fig. 8: Determination of the pole position. Cutting the magnetic strip
  
Fig. 9: Determination of the pole position. Joining the magnetic strip
Steps
1. If there is a cover strip, this is to be removed first.
2. To determine the pole division either use metal dust, a magnet magni-
fier or magnetic foil.
MSK2000 · Date 07.02.2018 · Art. No. 81962 · Mod. status 44/18


English