Photo And Video Recordings; Adjustments For The Recordings - Monacor Security DVT-440SET Bedienungsanleitung

3) For an announcement via the monitor micro-
GB
phone (15) to the speaker (20) of the selected
camera keep the button TALK (9) pressed. Then
the speaker symbol (h) changes from red to
green.
4) The camera pictures may also be zoomed so
that an enlarged cutout is shown on the monitor.
a) First select the camera picture to be viewed in
an enlarged size with the button
b) Go to the menu item "Resolution" in the menu
"Camera Setup" and select the adjustment
"Zoom" (chapter 6.2).
c) After deactivating the menu, the camera pic-
ture appears in an enlarged size. On the top
of the picture the symbol X2 (i) shows the
activated zoom function. The picture cutout
shown can now be moved with the buttons
, and
d) To deactivate the zoom function, activate the
menu (Camera Setup
or QVGA).

8 Photo and Video Recordings

For photo and video recordings insert an SD / SDHC
memory card (up to 32 GB) into the slot (16). The
bevelled corner of the card must point downwards
and to the unit. On the top of the picture the symbol
SD (d) flashes: The card is read in. Then the flash-
ing stops.
White SD symbol:
Red SD symbol:
No SD symbol:
Indication ERR:
To remove the card, slightly press it in so that it dis-
engages.

8.1 Adjustments for the recordings

1) Activate the main menu with the button MENU
(14). The submenu "Camera Setup" is selected.
Select the submenu "Recorder Setup" with the
button (12) and activate it with the button
ENTER (11).
2) The first menu item "Motion detect" is selected.
The motion sensor can be activated separately
for each camera at this menu item. If a move-
20
.
→
Resolution
The card is correct.
The card is full
Deactivate the write protec-
tion of the card
An error has occurred
ment is detected, a video recording starts for
3 minutes or a photo is taken.
a) The first camera is selected. To select
another camera, press the button
b) Use the button ENTER to activate and deac-
tivate the sensor for the camera selected. The
corresponding camera symbol shows the
adjustment:
or .
1
1
c) To adjust the sensor sensitivity, press the but-
ton AV (8). An adjusting scale appears:
d) Adjust the sensitivity with the buttons and
,
e) To exclude areas in the camera picture from
the motion detection, a mask can be applied.
→ For this purpose, press the button REC (13).
VGA
The camera picture appears with a grid of
30 × 40 fields which represent the individual
sensor fields.
f) On the top left a green frame with the size of
3 × 3 fields flashes. With this frame, fields can
be excluded from the motion detection. To
change the frame size to 1 field or 2 × 2 fields,
press the button AV (repeatedly).
g) Move the green frame with the buttons
and
from the motion detection and press the button
ENTER. The fields are now marked red and
deactivated for the motion detection. To reacti-
vate the fields, press the button ENTER again.
h) Select further sensor fields and press the but-
ton ENTER to extend the deactivated area.
i) To memorize and exit the mask, press the
button REC. To confirm, the message "Updat-
ing motion detect mask area" is shown. Then
the menu item "Motion detect" reappears and
the adjustments can be repeated for the other
cameras.
3) From the menu item "Motion detect" go to the next
menu item "Record type" with the button
the recording mode with the button
"Video" for video recordings
"Photo" for taking individual photos
motion sensor off
motion sensor on
to the fields intended to be excluded
or .
.
, ,
. Select
or :