Use; Gas Leaks; Electric Heating; Safety Tips 2 - Qlima GH 959 RF Benutzerhandbuch

Use only a correct low pressure regulator. Outlet pressure details: see rating label. Do not move the appliance when operating, shocks and
bumps may activate the safety device. Do not twist the flexible tubing or hose.

USE

The knobs for turning the gas heater ON are located on the upper part of the heater:
• Open the gas container (follow the user instructions provided with the low-pressure regulator).
• Turn the regulation knob into position 1 as indicated in fig. Press it all the way down and, at the same time, press the piezoelectric button;
this turns the atmosphere analyzer on. To keep the flame lit, the knob must be held pressed down for 20 seconds after ignition.
1. Minimum and Ignition
2. Medium
3. Maximum
4. Piezoelectric ignition
Release the knob and turn it to the position corresponding with the desired amount of heat:
• To turn OFF the device, close the gas container valve.(follow the instructions provided with the low-pressure regulator).
• Do not hold the regulation knob pressed down for longer than 40 seconds.
• Never move the heater when it is hot and/or in operation.

GAS LEAKS

If you think there may be a gas leak, please follow this procedure:
• Close the gas container valve. (follow the user instructions for the regulator);
• Extinguish all open flames, for instance stoves;
• Open windows in order to increase airflow circulation;
• Turn off electrical devices, for instance lamps;
• Prepare a bucket of soapy water;
• Open the gas container (follow the user instructions for the regulator);
• Brush the soapy water on all fittings and connections of the gas circuit;
• If there is a gas leak, bubbles will rise up from the location of the leak;
• If a leak is found, close the gas container (follow the user instructions for the regulator).
• Tighten the fitting and the metal rings of the connection;
• Open the gas container (follow the user instructions for the regulator) and repeat the procedure again.
If there is still a gas leak contact a professional and qualified engineer for help.

ELECTRIC HEATING

The electric heating system is designed for infrared radiation technology. Even if used in an unsealed large room the efficiency will be perfect.
There is a switch to select Gas or Electric heating. The heater has two heating elements, which can be used separately or together depending
on the need.
Operation:
a. Make sure that the plug is normally earthed. Put the plug into the socket.
b. Press switch "Fan" to get ready to use the heater and to start the fan.
c. Press switch "I" to start electric heating with half effect.
d. Press the other switch "I" to start electric heating with maximum effect if needed.
e. Turn OFF all switches after use. Remove the plug from the socket.
b c d
* turn thermostat to "High": electric heater will work to high room temperature
* turn thermostat to "Low": electric heater will switch off at lowest room temperature and will restart automatically when this lowest room
temperature is undercut

SAFETY TIPS 2

• Always place the heater facing the center of the room.
• Do never move the heater when it is burning.
• Prevent people, especially young children and elderly people from touching very hot surfaces.
• Never dry clothes at the top of the metal guard grill
• Keep all flammable materials at least one meter away from the heater.
• Never use a gas heater in a bathroom, bedroom. mobile home, high rise buildings or caravan. Toxic gases may cause serious health problems
in these situations.
• Never use or store solvents and pressure pack cans near a gas heater, even if the heater is turned off.
4
34
4
1 2 3