Storage And Disposal; Storage; Disposal - Comprag ADX20 Bedienungsanleitung

The air feed is too high.
Low air pressure at inlet.
High temperature of air at inlet.
Presence of
There is no change in the tower
condensate in
cycles.
the pipeline.
Insufficient supply of purge air.
Pressure in tower during regenera-
tion mode (maximum permissible
pressure, Pmax., is 0.05 MPa).
Service life of adsorbent.
7.

Storage and disposal

7.1 Storage of dryers
Dryers should be kept in a dry facility at a temperature between -10° and +45°С with max.
75% relative humidity. The facility should preclude the presence of precipitation.
7.2

Disposal

When dismantling the air dryer for disposal, it is advised that the components are divided
according to their constituent materials. You are advised to following safety instructions for
the recycling of each type of material.
Particular attention should be paid to recycling adsorbent.
The adsorbent contains oil particles from the compressor.
Do not release adsorbent into the environment. Remove it from the air dryer, as per point
5.3, and dispose of it for recycling.
COMPRAG Heatless adsorption compressed air dryers
Do not release adsorbent into the environment!
Check that the operating conditions conform
with requirements of the technical documenta-
tion.
Look at all aforementioned means of handling
faults.
Adsorbent replacement.
ADX Series
19