Installation And Setting; Operation - MEISTER CRAFT MET 25-32 Originalbetriebsanleitung

MC-5459530-Bediene-4er.qxd
• Check the magazine lock before
using.
• During breaks in work push the lock
switch (1) to „O/Off".
• Wear ear protectors and protective
gloves.
• Do not use the appliance to fasten
down electric cables or leads.
7 – Installation and setting
Inserting staples/nails
Unplug from the power source!
Open the slide lock (5) and remove the
slider (9) (Figure 2). Insert the
appropriate stable/nail strips into the
magazine (Figures 3 and 4).
Insert the slider (9) again and lock
(Figure 5).
Hammer force regulator
To protect the materials you are
working on, the hammer force
can be increased or decreased
steplessly according to
the surface and
materials being use.
Turn the regulator (8) in
the direction shown by
the arrow:
+ = increase force
– = decrease force
We recommend using a sample work
piece to determine the necessary force
before you start work.
21.09.2009 11:49 Uhr
8 – Operation
Use the filling level display (13) to check
whether there are staples or nails in the
magazine (4). If only the slider head can
be seen in the window, the other side
has nails in the magazine. Re-fill with
staples or nails as required.
CAUTION! Never put both
staples and nails into the
magazine!
Turning on the tool
CAUTION! Please pay attention
to the power voltage! The
voltage of the power supply must
correspond to the specifications on
the type plate!
Set the On/Off switch (3) to "I".
Switching-off the device
During breaks or when you have
finished work set the On/Off switch "0".
A slight warming of the unit during
operation is normal and is not a fault.
operation, take a break to allow the unit
to cool down.
Trigger lock
The device secured against accidental
triggering: ▼ The contact switch (2)
ensures that the stapler can only be
triggered when in contact with the
material. To do this press the contact
switch up against the work piece, use
both hands if necessary.
Seite 45
After 15 minutes of constant
45