AEG GS60AVB Benutzerinformation Seite 10

10 www.aeg.com
Whether you use a standard detergent
or multi-tabs (with or without salt), set
the proper water hardness level to
keep the salt refill indicator active.
Multi-tabs containing salt
are not effective enough to
soften hard water.
How to set the water softener
level
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously
the indicators
start to flash and the display is blank.
2. Press
• The indicators
off.
• The indicator
flash.
• The display shows the current
setting: e.g.
3. Press
the setting.
4. Press the on/off button to confirm
the setting.
6.3 The rinse aid dispenser
The rinse aid helps to dry the dishes
without streaks and stains.
The rinse aid is automatically released
during the hot rinse phase.
You can set the released quantity of rinse
aid between level 1 (minimum quantity)
and level 6 (maximum quantity). Level 0
will deactivate the rinse aid dispenser
and no rinse aid will be released.
Factory setting: level 4.
How to set the rinse aid level
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously
the indicators
start to flash and the display is blank.
and
, , and
.
, and
continues to
= level 5.
again and again to change
and
, , and
2. Press
• The indicators
off.
• The indicator
flash.
• The display shows the current
setting: e.g.
– The levels of rinse aid are
from 0A to 6A.
– Level 0 = no rinse aid is
released.
3. Press
the setting.
4. Press the on/off button to confirm
until
the setting.
6.4 The rinse aid empty
notification
go
When rinse aid chamber is empty, the
rinse aid indicator is turned on notifying
to refill rinse aid. If you are using multi-
tabs containing rinse aid and you are
satisfied with the drying result, you can
deactivate the notification for refilling
rinse aid. However, we recommend that
you always use rinse aid for best drying
performance.
If you use standard detergent or multi-
tablets without rinse aid, activate the
notification to keep the rinse aid refill
indicator active.
How to deactivate the rinse
aid empty notification
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously
the indicators
start to flash and the display is blank.
2. Press
• The indicators
off.
• The indicator
flash.
• The display shows the current
until
setting:
notification is activated (factory
setting).
.
, and
continues to
= level 4.
again and again to change
and
, , and
.
, and
continues to
= the rinse aid empty
go
until
go