Oerlikon CITOLINE 2000T Betriebs-Wartungs Und Sicherheitsanleitung Seite 8

EN
TYPE OF BREAKDOWN
Porous or spongy welds.
Porous or spongy welds.
Gas supply does not switch off.
Presslng torch trigger produces no
result.
GENERAL MAINTENANCE
POSSIBLE CAUSES
No gas.
Draughts in welding area.
Ciogged holes in diffuser.
Gas leakage due to rupture in supply hos-
es.
Solenoid valve blocked.
Faulty pressure regulator.
Poor quality gas or wire.
Worn or dirty solenoid valve.
Faulty torch trigger, disconnected or bro-
ken control cables.
Blown fuse.
Faulty power switch.
Faulty electronic circuit.
CHECKS AND REMEDIES
Check presence of gas and gas supply pressure.
Use a suitable screen. Increase gas delivery pressure if necessary.
Clear clogged holes using compressed air.
Check and renew faulty component.
Check solenoid operation an electrical connection.
Check operation by removing the hose connecting the pressure regulator
to the power source.
Gas must be extra-dry; change the cylinder or use a different type wire.
Dismantle solenoid; clean hole and obturator.
Remove the torch connection plug and short-circuit the poles; if the ma-
chine operates properly, check the cables and the torch trigger.
Renew using a fuse of the same rating.
Clean with compressed air. Ensure that wires are tightly secured; renew
switch if necessary.
Renew circuit.
7 EN