Wall Installation - Olsberg Corona Anleitung

Wall installation

IMPORTANT: DO NOT install the device directly be-
neath a wall-mounted power socket.
Fit the wall-fixing bracket (fig. 1) in such a way that the
convector unit lies in a horizontal position when in-
stalled. The attachment bracket should be fixed to a
level wall surface. Use the fixing screws (4.5x40) and
wall plugs (∅6mm) supplied for this purpose.
Two further screws are supplied to prevent the
wall bracket working loose after installation.
Screw them into the holes provided (Z) in the clip
mechanism of the wall-fixing bracket.
Note: Use the wall-fixing bracket as a template for
marking the position of the unit and the location
of the drill holes.
Dim. Dim.
Type
L A
15/192 340 156
15/193 340 156
15/194 420 236
15/195 500 178
15/196 580 248
15/197 660 320
15/198 740 405
15/199 900 535
Observe the international safety regulations regarding
minimum clearances when installing the unit in rooms
equipped with bath or shower.
If the unit's connection lead is damaged, ensure that it
is replaced immediately with the appropriate original
part (available from the manufacturer or an authorized
service provider).
Locate the device on the open clips at the bottom, on
the wall-fixing bracket, and push in until the spring-
loaded catches at the top and/or sides engage in the
recesses provided in the rear panel.
To release the spring-loaded catch once it has en-
gaged, push on the upper or lateral clip with a screw-
driver or similar (see fig.1 – item Z and fig.2 – item E).
10
Dim. Dim. No. of fixing
B C screws
94 90 3
94 90 3
94 90 3
215 107 4
204 128 4
212 128 4
207 128 4
237 128 4
Convector unit 15/192 /193 /194
Convector unit 15/195 /196 /197 /198 /199
fig.1
fig.2
E
item