Dce 11/13 Rc - STIEBEL ELTRON DCE 11/13 Bedienung Und Installation

oPERATIoN
settings
4.2

DCE 11/13 RC

Using the wireless remote control you can adjust the temperature
setting wirelessly. The selected temperature is displayed on the
remote control.
The wireless remote control provided is registered to the receiver
module. Only a registered remote control can alter the settings
on the appliance.
The wireless range is reduced by obstacles between the appliance
and the remote control.
You can mount the wireless remote control anywhere using the
wall mounting bracket supplied in the standard delivery.
Operation
1
1 Display
2 Temperature selection 20 °C – 60 °C in 0.5 °C steps, using the
+ and - buttons
3 Memory keys "1" and "2"
The wireless remote control is normally in power save mode,
which means the display is switched off. Pressing any key activates
the wireless remote control, the temperature display appears. The
progress bar indicates that data is being transmitted to the device.
If no key is pressed within 10 seconds the wireless remote control
automatically switches back to power save mode.
The selected temperature is also maintained in power save mode.
Saving temperature to memory keys
f Select the required temperature. f
f Press memory key "1" or "2" for 2 seconds. The temperature f
display flashes once to confirm.
f The heater of the appliance can be switched off (display f
message OFF). To switch the heater off, select the minimum
temperature (20 °C), then press the "-" button once.
www.stiebel-eltron.com
1
2
3
2
Changing the battery
1
1 Battery change symbol
When the battery symbol illuminates, change the battery in the
wireless remote control. A change of battery may also become
necessary when the temperature settings are not received by the
device and/or the transmission range decreases.
Material losses
!
f Remove the old battery. f
Note
The wireless remote control is powered by a lithium but-
ton cell.
Remove spent batteries. Leaking batteries cause damage
which is excluded from any warranty. Non-rechargeable
batteries must not be recharged.
Never use rechargeable batteries.
If the appliance is not used for a prolonged period, re-
move the battery (see chapter "Troubleshooting / Replac-
ing the battery in the mini wireless remote control").
f Open the casing of the wireless remote control by unscrew- f
ing the 4 screws on the underside of the device.
f Replace with a CR 2032-type battery. Never use rechargeable f
NiCd batteries. Ensure correct polarity of the new battery (+
at the top).
f Put the casing back together and re-insert the 4 screws. f
When reassembling the casing, do not damage the all-round
gasket.
The stored values for keys 1 and 2 are retained during the battery
change.
Battery disposal
Never dispose of batteries with domestic waste. Spent
batteries contain hazardous substances that are detri-
mental to the environment and human health. Dispose
of spent batteries through your dealer or via a central
recycling point for special waste.
DCE 11/13| DCE 11/13 RC| DCE 11/13 H |
1
2
23