iSi Cream Profi Whip Gebrauchsanleitung Seite 21

The charger is difficult to screw on.
1. The charger being used is not suitable.
The cream charger will not puncture.
1. The charger being used is not suitable.
2. The charger was inserted backwards.
3. The puncturing unit has been damaged.
The decorator tip will not unscrew.
1. The decorator tip was attached too tightly.
2. Interim cleaning has not been carried out
During operation, gas is leaking through the
dispensing piston or decorator tip.
1. The device was used without an attached tip.
2. The dispensing piston seal has been damaged.
47026405_CPW_GA_kurz.indd 14
Only use original iSi cream chargers.
Only use original iSi cream chargers.
Insert the charger correctly (see
diagram: Instructions for use).
Send the whipper to iSi or to a service
center.
Screw on the decorator tip so that it
is not too tight, but tight enough to be
secure.
"Release the pressure." If the decorator
tip still does not unscrew, contact iSi or
a service center.
regularly.
Interim cleaning needs to be carried out
every 1–2 hours.
Hold the bottle with the tip under
potable water and clean the tip in warm
running water.
Before screwing on the charger, make
sure that the decorator tip is attached to
the dispensing piston.
"Release the pressure" and then set-up
the whipper again.
The dispensing piston needs to be
replaced and is available as an original
iSi spare part.
14
08.11.18 17:17