Seca 285 Bedienungsanleitung Seite 114

114 •
If the wireless group "0" already exists and you wish
to set up another wireless group with this device,
use the arrow keys to select another ID (here:
wireless group 1 "ID 1").
7. Confirm your selection for the wireless group.
The device suggests a channel number for channel
1 (here C1 "0").
You can either accept the channel number
suggested or select another channel number using
the arrow keys.
8. Confirm your selection for channel 1.
The device suggests channel number for channel 2
(here C2 "30").
You can either accept the channel number
suggested or select another channel number using
the arrow keys.
NOTE
Two-digit channel numbers are displayed
without a space. The display "C230" means:
channel "2", channel number "30".
9. Confirm your selection for channel 2.
The device suggests a channel number for channel
3 (here C3 "60").
You can either accept the channel number
suggested or select another channel number using
the arrow keys.
10. Confirm your selection for channel 3.
St0p
The message appears in the display.
The device is waiting for signals from other devices
with wireless transmission capability within range.
NOTE
With certain devices, a special switch-on
procedure must be followed if they are to be
integrated in a wireless group. Consult the user
manual for each device.
11. Switch on the device you wish to integrate in the
wireless group, e.g. a wireless printer.
A beep can be heard when the wireless printer is
detected.