WIK 9711 Bedienungsanleitung Seite 13

08_Innenseiten_Sprachen
No liability is accepted for any damage
resulting from use for other purposes, faulty
operation or amateur repairs. Guarantee ser-
vices are also excluded in such cases.
The appliance is not intended for catering
purposes!
Operating the appliance
for the first time
FIG. 1
Before using the appliance for the first
time, fill the appliance up to the max. filling
amount and boil twice. Do not drink the
espresso prepared!
Warning! Danger of burns!
The appliance becomes very hot when
preparing espresso! Allow the appli-
ance to cool down completely
between the two boiling procedures
and rinse it out with cold water.
Method:
●
Adjust the required length of cable on
the power base "k" .
Wind any cable not required onto the
cable winder. Guide the cable through
the recess (1).
●
Connect the power base "k" according to
instructions (observe "For your safety").
●
Put the appliance into operation (see
"Prepare the espresso").
Prepare the espresso
FIG. 2 – 12
Fill the appliance
●
Unscrew stainless steel pot " d " from
stainless steel water container " i " (2).
☛
Note
Make sure that seal " f " and filter disc
" e " are clean and not damaged and are
inserted into the pot as illustrated (3) .
22.06.2006 15:02 Uhr Seite 13
●
Remove coffee filter "g" from the stain-
less steel water container (4).
●
Fill stainless steel water container "i" to
just below the safety valve – this is the
max. permissible filling amount (5).
Warning! Risk of scalding!
Do not exceed the max. permissible
filling amount.
☛
Note
If you want to prepare less espresso,
observe the minimum filling volume of
200 ml corresponding to 4 cups of
espresso. Going below this filling vol-
ume means that the coffee might
become too cold. With a maximum fill-
ing volume of 300 ml you can make
6 cups of espresso. 50 ml correspond to
approx. 1 cup of espresso.
●
Insert coffee filter "g" into the stainless
steel water container.
●
Fill coffee filter "g" to just under the
brim with espresso powder (7). Do not
press the espresso powder down.
●
Clean the brim of the coffee filter to
remove excess espresso powder and
screw the stainless steel pot tightly back
onto the stainless steel water container
as illustrated (8). Do not use the handle to
screw the container together, as this can
damage the appliance.
Warning! Risk of scalding!
Hot steam can escape from the safety
valve "h" ! Ensure that once the container
is screwed together, the safety valve "h"
is on the opposite side of the handle.
☛
Note
The boiling procedure can be interrupted
any time with the ON-/OFF switch "j" .
Switch on the appliance
●
Place the appliance on the connected
power base (9).
●
Switch on the appliance with the lid
closed by pressing the ON-/OFF switch
"j" (10). While heating, the red heat indi-
cator lamp lights up.
13