Cleaning And Care - SCHUBERTH F220 Handbuch

F220
Use of the helmet with a full-face mask with harness
The lining of the SCHUBERTH F 220 is fi tted with a quick-adjustment facility to
enable use with a full-face mask with strap harness. By releasing the button at the
second hole on the right-hand side of the headband and pulling the headband strap
accordingly you can quickly and individually adjust the helmet width to enable you
to wear a full-face mask with strap harness in combination with the helmet.
Adjustment: First check for correct size adjustment of the headband without the
mask and, where necessary, adjust accordingly by inserting the studs into the
corresponding holes in the holed section on the left side (see also "Size adjust-
ment").
1) Press and release the button (F) on the
head ring's quick-release fastener.
2) The headband can now be pulled apart
as far as the bridge (G) of the holed
section.
3) Now put on the mask and make the
corresponding adjustment with the
holed section (H) so that the helmet now
fi ts properly even with the mask straps.
Having done this, close the headband again at the quick adjuster and press the
button into place. The normal helmet width has now been adjusted and the quick
adjuster can be used at any time by releasing the button.

Cleaning and care

The helmet shell and inner lining should only be cleaned with lukewarm soapy
water. The lining of the helmet can also be treated with disinfectant (e.g. Heliosept
Medical Spray). Use correspondingly approved cleaning agents and disinfectants
only! On no account use solvents.
22
F
G
H