SCHUBERTH F220 Handbuch Seite 19

Important! The F 220 satisfi es the requirements of EN 443:2008 on the retaining
system if the chinstrap supplied by the manufacturer is worn and adjusted
according to the provisions.
Operating the visor
When raised and locked in place, the visor of the F 220 protrudes slightly from
the helmet shell. This makes it easy to hinge it down again, even with protective
or work gloves.
By applying appropriate pressure to the lower edge of the visor, the visor can
then be raised again and retracted into the helmet shell. The helmet's visor
mechanism ensures the visor locks fi rmly into each end position. The visor must
be properly mounted on the helmet.
Use of the helmet in combination with a mask
The SCHUBERTH F 220 is designed for use with a respirator mask. A respirator
mask can be attached to the helmet by fully inserting the connectors at the sides
into the mask locks located on the left and right sides of the helmet. The mask can
be removed again by pressing the external buttons to open the mask locks and at
the same time pulling it gently towards the rear by means of the laterally mounted
mask straps (locking function). For further details and instructions on fi tting a
mask as well as correct handling and operation thereof, please refer to the
respective manufacturer's user manual.
21