SCHUBERTH F220 Handbuch Seite 17

Notes on use of the helmet
The SCHUBERTH F 220 fi refi ghter helmet is designed for use in fi refi ghting in
buildings, rescue and salvage activities, for work associated with road accidents
and generally for activities within the scope of a fi reman's duties. Use for any other
purpose is to be ruled out and will release SCHUBERTH from any and all liability.
The visor is specifi cally designed for use with the SCHUBERTH F 220 fi refi ghter
helmet and must not be used for any other form of application.
Important! This helmet only gives full protection when sitting optimally on your
head, the headband is properly adjusted to your head circumference and the
chinstrap is closed. Detachable parts may not be worn/used separately.
Only wear the helmet when it is fully assembled.
Important! This helmet is designed to absorb the effect of only one impact. In the
same way as the crumple zone of a car's bodywork, the F 220 absorbs a strong
force acting on it through complete or partial destruction of the helmet shell and
lining structures. You should therefore replace the helmet with a new one if it has
been subjected to heavy impact or forces.
Liability for functioning and damage
Liability for the functioning of the SCHUBERTH F 220 fi refi ghter helmet in all
cases passes to the owner or operator to the extent that the helmet is improperly
serviced or repaired by persons other than staff of SCHUBERTH GmbH or in the
event that it is used for any application other than its intended purpose.
SCHUBERTH GmbH will accept no liability for damage caused by or arising from
non-compliance with these user instructions.
19