Mounting - HomeMatic IP HmIP-SWO-B Montage- Und Bedienungsanleitung

Mounting

5 Mounting
Before starting to set-up the device, you have to connect
the single components of the weather sensor supplied.
To do this, please proceed as follows:
Step 1:
• Remove the not yet completely assembled
weather sensor and the anemometer (A) from
the packaging.
Put the anemometer to tube 2 (F) above the main
•
sensor (B).
• Please make sure that the notch of the rotary axis
matches with the screw hole (see fig. 4).
• Fasten the anemometer with the screw (see fig.
5).
Step 2:
You can install the weather sensor using the stainless
steel mast (F) or using the hose clamp (I) and the tube
connector (H) for mounting the device to other tubes or
mounting brackets.
Alternative A: Mounting with stainless steel mast
Remove the tubes of the stainless steel mast (F)
•
from the packaging.
• Join the pipes together and position the notches
of the single pipes on top of each other.
• Put the previously mounted weather sensor to
38