Closing The Door; Installation - Electrolux IG1235SN Benutzerinformation

Problem
Temperature cannot be set. The FastFreeze or Shop-
DEMO appears on the dis-
play.
The temperature in the ap-
pliance is too low/too high.
If the advice does not lead to
the desired result, call the
nearest Authorized Service
Centre.

8.2 Closing the door

1. Clean the door gaskets.

9. INSTALLATION

WARNING!
Refer to Safety chapters.
Possible cause
ping function is switched
on.
The appliance is in demon-
stration mode.
The temperature regulator
is not set correctly.
The door is not closed cor-
rectly.
The food products' temper-
ature is too high.
Many food products are
stored at the same time.
The door has been opened
often.
The FastFreeze function is
switched on.
There is no cold air circula-
tion in the appliance.
2. If necessary, adjust the door. Refer to
3. If necessary, replace the defective
9.1 Location
Solution
Switch off FastFreeze or
Shopping manually, or wait
until the function resets au-
tomatically to set the tem-
perature. Refer to "Fast-
Freeze or Shopping func-
tion".
Keep the OK button press-
ed for approximately 10
seconds until a long sound
is heard and display shuts
off for a short time.
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products tem-
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Open the door only if nec-
essary.
Refer to "FastFreeze func-
tion".
Make sure that there is cold
air circulation in the appli-
ance.
"Installation".
door gaskets. Contact the Authorised
Service Centre.
Refer to the assembly
instructions for the
installation.
ENGLISH 61