Electrolux IG1235SN Benutzerinformation Seite 60

60 www.electrolux.com
Problem
A rectangular symbol is
shown instead of numbers
on the Temperature Dis-
play.
The compressor operates
continually.
There is too much frost and
ice.
The compressor does not
start immediately after
pressing the FastFreeze, or
after changing the tempera-
ture.
Water flows on the floor.
Possible cause
The temperature in the ap-
pliance is too high.
The door is left open.
The temperature in the ap-
pliance is too high.
Temperature sensor prob-
lem.
Temperature is set incor-
rectly.
Many food products to be
frozen were put in at the
same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The door is not closed cor-
rectly.
The FastFreeze function is
switched on.
The door is not closed cor-
rectly or the gasket is de-
formed/dirty.
Food products are not
wrapped properly.
This is normal, no error has
occurred.
The melting water outlet is
not connected to the evap-
orative tray above the com-
pressor.
Solution
Refer to "Door Open
Alarm"or "High Tempera-
ture Alarm".
Close the door.
Contact a qualified electri-
cian or contact the nearest
Authorized Service Centre.
Contact the nearest Author-
ized Service Centre (the
cooling system will continue
to keep food products cold,
but temperature adjustment
will not be possible).
Refer to "Operation" chap-
ter.
Wait some hours and then
check the temperature
again.
Refer to climate class chart
on the rating plate.
Allow food products to cool
to room temperature before
storing.
Refer to "Closing the door".
Refer to "FastFreeze func-
tion".
Refer to "Closing the door".
Wrap the food products
better.
The compressor starts after
a period of time.
Attach the melting water
outlet to the evaporative
tray.