Using The Buckle - Baninni ROADTRIP BN513 Gebrauchsanleitung

5.4.1 Using the buckle

Step1. Put the two metal sections of the buckle connectors together (fig. 1),
Step2. Slot the two buckle connectors into the slot in the top of the buckle until
they "click" into place (fig. 2)
Step3. Check the harness is correctly locked by pulling the shoulder straps
upwards (fig.3).
To release the harness, press the red button on the buckle downwards.
6. USAGE FOR THE AGE GROUP II + III
The harness system must be removed from the seat (see point 5.1) when used
for these age group II,III, which means from 15kg to 36kg . Only the 3-point
vehicle belt system can be used to buckle up the child car seat.
6.1 Removal of the harness
fig.3
Keep harness with all parts in a safe place, to use in the future.
Step1. Loosening the harness (see
point 4.3), Turn the seat to the back
(Fig. 1)
Step2. Slide both of the harness straps
off the harness connector (Fig. 1).
fig.1
Step3. Slide the belt of the chest pads
off the Chest pad connector (Fig. 2)
Step4. Pull the strap till the steel pole
gets out of the slot (Fig. 3). Now you
can remove the belts as well as the
tongue in an upwards direction.
Installation of the harness is carried out
in reverse order to removal.
fig.2