Philips HD3720 Benutzerhandbuch Seite 22

ENGLISH
24
Problem
Tap unit
It is difficult to place the
tap unit onto the keg.
It is difficult to press
the release buttons to
remove the tap unit.
It is not possible to
place the keg with the
assembled tap unit in
the appliance.
The tube cannot be
removed from the tap
unit.
It is difficult to place the
tube into the tap unit.
LCD display/LED indicator lights
The red indicator light
flashes (HD3610).
There is a green dash
on the display and the
appliance does not
work (HD3720).
There is a green or red
dash on the display
and the background
light flashes (HD3720).
Solution
Make sure no old beer is left in the tap unit. Clean the entire
tap unit with hot water and, if necessary, some washing-up
liquid.
First remove the keg from of the appliance. Then press the
release buttons to remove the tap unit from the keg.
Beer residues may cause the tap unit to stick to the keg.
Clean the tap unit with hot water and, if necessary, some
washing-up liquid to dissolve beer residues. Then remove the
tap unit from the keg.
Make sure the tap unit is placed correctly on the keg. Push
the tap unit down firmly when you place it onto the keg. See
chapter 'Preparing for use' , section 'Placing the tap unit onto
the keg' .
Check if you have lifted the blue locking levers properly and
push them down after you have installed the keg.
Remove the tap unit first before you remove the tube. Rinse
the tap unit with hot water. Press the tube release button and
pull the tube out of the spout.
Make sure the tube is placed correctly (see chapter 'Preparing
for use' , section 'Placing the tube into the tap unit').
Make sure you clean the tap unit with hot water before you
insert a new tube.
The tube may be broken. Contact the PerfectDraft call centre
in your country to obtain a new tube.
Remove the tap unit, clean it and reinstall the tap unit. If this
does not help, try another keg with a new tube.
If the problem continues to occur, please contact the
PerfectDraft call centre in your country.
Make sure that the tap unit is placed correctly (see chapter
'Preparing for use' , section 'Placing the tap unit onto the keg').
Remove the tap unit, clean it and reinstall the tap unit. If this
does not help try another keg with a new tube.
If the problem continues to occur, please contact the
PerfectDraft call centre in your country.