Philips HD3720 Benutzerhandbuch Seite 11

3 Push the tube connector into the opening in the tap unit
('click').
Placing the keg into the appliance
Never place the keg into the appliance if you have not
assembled the tap unit and the tube properly. See sections
'Placing the tap unit onto the keg' and 'Placing the tube into
the tap unit' in this chapter.
1 Slide the release button to the right to open the doors.
2 Lift the two blue locking levers completely.
3 Tilt the keg with the assembled tap unit slightly forward
and put it into the appliance.
- First put the keg on the cooling plate of the appliance.
- Then put the keg upright by sliding the tap unit between the
blue locking levers.
4 Push down the blue locking levers until they are in
horizontal position.
If you are unable to put the locking levers in horizontal position,
you have not put the keg into the appliance in the right
position. Take out the keg and follow steps 1 to 3 again.
After you have installed the keg (even the first time), the
,
pump runs for a few seconds.
ENGLISH
13