Troubleshooting - Electrolux KTI6430E Benutzerinformation

7. TROUBLESHOOTING

You cannot activate the
appliance or operate it.
The appliance deacti-
vates.
The residual heat indica-
tor does not come on.
The sensor fields become
hot.
comes on.
comes on
comes on
and a number come
on
Problem Possible cause
You touched 2 or more
sensor fields at the same
time.
There is water or fat
stains on the control pan-
el.
You put something on the
sensor field .
The cooking zone is not
hot because it operated
only for a short time.
The cookware is too large
or you put it too near to
the controls.
The Automatic Switch Off
operates.
The Child Safety Device
or the Lock function op-
erates.
No cookware is on the
cooking zone.
The cookware is incor-
rect.
The diameter of the bot-
tom of the cookware is
too small for the cooking
zone.
There is an error in the
appliance.
ENGLISH
Remedy
Activate the appliance
again and set the heat
setting in less than 10
seconds.
Touch only one sensor
field.
Clean the control panel.
Remove the object from
the sensor field.
If the cooking zone oper-
ated sufficiently long to
be hot, speak to the serv-
ice centre.
Put large cookware on
the rear cooking zones if
necessary.
Deactivate the appliance
and activate it again.
Refer to the chapter "Dai-
ly Use".
Put cookware on the
cooking zone.
Use the correct cook-
ware.
Move cookware to a
smaller cooking zone.
Disconnect the appliance
from the electrical supply
for some time. Discon-
nect the fuse from the
electrical system of the
house. Connect it again.
If comes on again,
speak to the service cen-
tre.
11