EdilKamin LOGO Installations-, Betriebs- Und Wartungsanleitung Seite 36

POSSIBLE TROUBLESHOOTING
7) Signalling: smoke °C/high.
Problem: turns off due to exceeding maximum smoke temperature.
Actions: • Check the pellet type
• Check for anomalies with the smoke extraction motor
• Check to see if there are any obstructions in the smoke channel
• Check correct installation
• Check gear motor "drift"
• Check to make sure there is an air intake in the room
8) Signalling: "Battery check"
Problem: The insert does not stop but the error appears on the display.
Actions: • The buffer battery of the control board needs changing (DEALER).
9) Problem: Remote control not working
Actions:
• closer to the receiver of the insert
• check the battery and if necessary, replace it.
10) Problem: Outlet air not hot
Actions:
• clean heat exchanger from inside the rebox.
11) Problem: During ignition, the differential switch trips (DEALER):
Actions: • check moisture content of ignition resistance
12) Problem: Does not ignite:
Actions:
• clean combustion chamber.
NOTA
Warnings are shown until you intervene and press the 0/1 key on the control panel.
Do not ignite the stove until the problem has been checked and resolved.
- 36
-