Identifying Damages - Zummo Z06 Nature Bedienungsanleitung

7.3. IDENTIFY DAMAGES
Problem
The display does
not become lit
The display shows
message Error
The display shows
message Error and
a flashing Icon.
Blade breakage
Oranges are not
thoroughly
squeezed
Oranges dash out
from the paddle
The filter cleaner is
not removing the
pulp from the filter
For any queries or request for spare parts, please state the model and identification
39
Cause and/or solution
Lack of electrical current.
Fuse burnt out (fig. 17).
Power cable improperly connected.
Turn on the power switch (fig. 6).
Humidity in electronic plate. Provide dry heat to the plate.
Basket out of place (Disp.2).
Front cover out of place. (Disp. 3a and 3b).
Squeezer tray out of place (Disp. 4).
Containers out of place (Disp.5a and 5b).
Check to see if frozen oranges are being squeezed.
Check if peelings have piled up on the tray that holds squeezers.
Check to see if balls have been left un-tightened.
Check to see if peelings are left stuck to the inside of cups.
To unblock the machine, use an Allen key of 5mm which you will find at
the right side of the grid. Introduce it in the right side lateral hole
(Fig.22) and, with the machine switched off, turn the key clockwise till
cups are up and the machine is unblocked.
WARNING: Make sure the Allen key is removed before switching the
machine on.
The blade has been placed over its shaft.
Washers are missing under balls.
Orange peels are too thin; place a maximum of one washer under
balls.
The paddle shaft is too dry; proceed to grease it (fig. 21).
A piece of orange peel is preventing the movement of the pulp scraper
filter.
The filter set has been assembled in reverse. Check that the drive shaft
dovetails properly with the hexagonal actuator (fig. 11-12).
number of your machine (fig.19).