Stand By; Final Operation Signal; Cleaning - Zummo Z06 Nature Bedienungsanleitung

 Once the number of peels has been selected, press STOP and that quantity will be held in the
machine's memory.
 Once the machine reaches the desired quantity it will stop and the containers/chutes on the
display panel will blink. To continue juicing, the peel deposit must be emptied and then the ON
button pressed in order to reset the counter
TO DEACTIVATE THE PEEL COUNTER.
Repeat the previous operation and set the counter to zero.

6.6. STAND BY

The machine has a stand-by power-saving system which is activated automatically after 5 minutes.
When the machine is on Stand-By, the display light goes out and all the icons except the one for the
machine are disabled.
To exit this situation, press any of the three buttons on the plate.
To deactivate the Stand By, repeat the 7.2. section process by entering the code 8024.
To activate, repeat the process by entering the code 8023.

6.7. FINAL OPERATION SIGNAL

To activate the beep signal, repeat the 7.2. section process by entering the code 8548. After
connecting the machine when the machine finish a service the machine beeps.
TO DEACTIVATE THE BEEP SIGNAL
Repeat the process by entering the code 8549.

6.8. CLEANING

The machine squeezing area and parts must be cleaned daily.

If the machine is in operation, stop it always using the Programmer button Stop. Never attempt to
stop the machine using the main switch. Failure to follow this recommendation will cause the
machine to stop in a position that impedes cleaning; possibly leading to breakage of parts due to
poor handling.

Disconnect the machine turning the power switch off (fig. 6). Then the digital display will turn off.

Remove the Front Cover and wash it using a damp cloth with a neutral soapy solution.
(ATTENTION! NEVER use products that may scratch it).

Remove the containers and wash them with the same neutral soapy solution.

Remove the filter tray to get access to the Juice tray fastening nuts (fig. 5).

Juice tray and Blade are removed by unscrewing the fastening nuts and pulling outwards
horizontally (Fig. 8).

Unscrew the Balls inside the Juice tray (Fig. 9). You may use a dishwasher to wash Juice tray, Filter,
Filter Tray and Blade. TAKE EXTRA CARE WITH THE BLADE (fig. 3) since it is very sharp and
may cause injuries.

To remove the cups, we recommend that you loosen the fastening screws a little and pull outwards;
they will be released and can then be easily removed
31