Description
3.2 Connection components
3.2
Connection components
Interfaces and power supply
Location of the connector elements
Pos
Name
①
24 VDC
②
DVI/VGA
③
USB
④
LAN1: X2 P1
⑤
ADMIN: X2 P2
⑥
COM1
⑦
USB strain-relief
fastener
⑧
PE terminal
42
Description
Connection for a 24 V DC power supply
DVI/VGA connection for CRT or LCD monitor with DVI interface
The interface is not supported.
4 USB 2.0 connections, high-speed / low current
RJ-45 Ethernet connector for 10/100/1000 Mbps, data port ("esa0" interface)
RJ-45 Ethernet connector 2 for 10/100/1000 Mbps, management port ("admin" interface)
Serial port (RS232) 9-pin D-Sub connector
The USB strain relief must be fastened to the device enclosure with an oval-head screw
(M4 thread). The USB cables can be fastened to the strain-relief assembly with a cable
tie.
The PE terminal (M4 thread) must be connected to the protective ground conductor of the
plant, in which the device is to be installed. The minimum conductor cross-section may not
be less than 2.5 mm
.
2
Compact User Manual, 11/2012, A5E03740572-03
SCALANCE WLC711