Connecting The Headphones To A Second Bluetooth ® Device - Silvercrest SBKP 1 A1 Bedienungs- Und Sicherheitshinweise

Pairing with a new Bluetooth
6 seconds until the LED
This indicates the headphones are now in pairing mode, which remains ac-
tive for 5 minutes. The headphones will switch off if they do not detect a
Bluetooth device to connect to and sound 4 beeps.
®
Now connect your communication device (mobile phone or computer) via
Bluetooth with the headphones. Please refer to the notes in the instructions
®
for your communication device. Select the entry "SBKP 1 A1" from the list
of devices detected by your computer or mobile.
Once the connection has been established, the LED will briefly flash blue
twice every 3 seconds.
Please note, your communication device must support Bluetooth
4.0 to use all options.
If you come into range of the paired device with the headphones switched
on, a Bluetooth
You may need to approve the connection on the communication device.
Please refer to the instructions for use of the communication device on this
topic!
If you leave the range of your communication device with your headphones,
the LED will flash blue once every 2 seconds. If the connection is not restored
within 5 minutes, the headphones will switch off.
The headphones may be manually switched off by holding the
button for 3 seconds until acous tic signal sounds and the LED goes
3
out.
Connecting the headphones to a second
Bluetooth
The headphones may be connected to two Bluetooth
at the same time. If the headphones are already connected to a device, follow
the steps below to connect to the second device:
Activate multipoint mode by pressing and holding
Acoustic signal sounds. The first communication device (mobile phone or
computer) is disconnected.
device: Hold the
®
flashes red and blue and acoustic signal sounds.
2
connection will automatically be established.
®
device
®
button for approx.
3
Standard
®
communication devices
®
button for 2 seconds.
6
GB 13