oventrop Regusol X-Uno 25 Montage- Und Bedienungsanleitung Seite 64

Installation
10. Suspend rear insulation shell (2) in the angled
wall bracket (1) and use as drilling jig for the
fixing screws of the product assembly.
11. Choose four drill holes (arrows) for fixing the
product assembly and mark them on the wall.
12. Take off rear insulation shell. Drill holes for the
fixing screws of the product assembly and
equip with dowels.
13. Suspend rear insulation shell (2) in the angled
wall bracket (1).
14. Suspend product assembly (3) in the angled
wall bracket and mount onto the wall with the
help of screws M8x100 and the enclosed
washers.
15. Install pipework according to the installation
scheme, see "Connection of the supply
pipes".
16. Connect electric cabling and sensors, see
"Electrical connection".
64
Illustr. 18: Rear insulation shell, angled wall bracket