Specifications - Makita 5104 Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Lever
1-2. Scale
1-3. Depth guide
2-1. Clamping nut
2-2. Indication
2-3. Angle plate
3-1. Clamping nut
4-1. Base
4-2. Top guide
4-3. Rip fence (Guide rule)

SPECIFICATIONS

Max. Cutting depth
No load speed (min
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for performing lengthways and
crossways straight cuts and mitre cuts with angles in
wood while in firm contact with the workpiece. With
appropriate Makita genuine saw blades, other materials
can also be sawed.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
Noise
The typical A-weighted noise level determined according
to EN60745:
Model 5104S
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Wear ear protection
Vibration
The vibration total value (tri-axial vector sum) determined
according to EN60745:
Explanation of general view
5-1. Switch trigger
5-2. Lock-off button
6-1. Hex wrench
7-1. Hex wrench
7-2. Shaft lock
8-1. Hex bolt
8-2. Outer flange
8-3. Saw blade
8-4. Inner flange
9-1. Base
Model
Blade diameter
at 0°
at 45°
-1
)
Overall length
Net weight
Safety class
) : 86 dB(A)
pA
) : 97 dB(A)
WA
5104
260 - 270 mm
ENE078-2
Model 5104S
Work mode : cutting wood
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Work mode : cutting metal
ENF002-2
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
ENG905-1
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
ENG900-1
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
3
9-2. Rear handle
9-3. Front handle
10-1. Rip fence (Guide rule)
11-1. Vacuum cleaner
12-1. Base
12-2. Adjusting screw
13-1. Triangular rule
14-1. Limit mark
15-1. Brush holder cap
15-2. Screwdriver
5104S
270 mm
95 / 100 mm
69 / 73 mm
3,800
405 mm
9.2 kg
/II
2
) : 2.5 m/s or less
h,W
2
2
) : 2.5 m/s or less
h,M
2
ENG901-1