Symbols; Operating Elements; Applications; Description - Protool SSP 200 EB Original Bedienungsanleitung

2

Symbols

Double insulation
Warning of general danger
Risk of electric shock
Use protective goggles!
Wear ear protection!
Wear a dust mask!
Use protective gloves!
Do not expose to rain!
Unplug the cord immediately if it is
cut or damaged
Read the instructions
Acoustic output value
Not to be included in municipal refuse
Advice or tip
►
3

Operating elements

[1-1] Unblock button
[1-2] On/off button
[1-3] Guide ruler
[1-4] Guide bar cover
[1-5] Manual clamp screw
[1-6] Guide runner
[1-7] Front auxiliary handle
[1-8] Oil gauge
[1-9] Oil cap
[1-10] Rotary suction adaptor
[1-11] Chain adjustment wheel
[1-12] Oil feed adjuster
[1-13] Clamping lever for reverse tilt lock
[1-14] RPM selector
[1-15] Rear auxiliary handle
[1-16] Parallel stop
[2-1] Chain sprocket cover
[2-2] Fastening wheel
[2-3] Chain
[2-4] Guide bar
[2-5] Hole for tension bolt
[2-6] Tension bolt
[2-7] Clamping bolt
[2-8] Chain sprocket
[2-9] Chain adjustment wheel
[3-1] Clamping lever for reverse tilt lock
[4-1] Cut indicator for 0°
[4-2] Hand screw for cutting angle
adjustment
[4-3] Bevel indicator
[4-4] Cut indicator for 45°
[4-5] Cut indicator for 60°
[4-6] Cut profi le indicator for 0°
[5-1] Oil level indicator
[5-2] Oil feed adjuster
[6-1] Distance screws
[7-1] Guide rail
[7-2] Gripper
[7-3] Angle adjuster
[7-4] Connecting spring
[7-5] Quick clamp
[8-1] Safety snap ring
[8-2] Washer
[8-3] Chain sprocket
[8-4] Spindle
Accessories shown or described are not
necessarily included with this tool.
4

Applications

4.1 Description

The SSP 200 EB sword saw was developed
for multi-purpose carpentry work. The ma-
chine can make rectangular cuts and ad-
justable angle cuts to a depth of 200 mm.
Various types of chains allow you to se-
lect the right tool for the job. A cutting an-
gle as large as 60° can be set quickly and
precisely using two tilting segments and a
clearly legible bevel indicator. The machine
is equipped with a pull-out guide ruler that
can be placed on either side of the runner
and guarantees a straight, accurate cut.
The guide bar can be quickly tilted back 10°.
Chain tension can be comfortably adjusted
using a wheel that is easily accessible from
the main handle. A suitably shaped port for
routing away sawdust keeps the machine
clear and can be attached to a suction hose.
During cutting, the chain receives optimal lu-
brication from the oil feed pump. Once turned
on, the motor runs smoothly up to maxi-
mum RPM, thanks to an electronic control
unit. The motor is electronically protected.
23