Nice BIO Serie Anleitungsheft Seite 20

After a few seconds 5 flashes will follow to indicate that the memory has been reset and is empty. If this
does not occur, repeat the entire operation from scratch.
CHECKING THE NUMBER OF CODES STORED (only for special BB2BK versions)
- Press the receiver key twice;
!
- Count the number following flashes. Each flash equals a code.
If there are a large number of codes and you wish to end early, press the key for a sec.
CHECKING THE 2nd LEARNING LOCK
- Press the key on the receiver a while and wait for 2 flashes to indicate elapsed time
!
(approx. 5 sec.);
- If the second flash lasts longer than the first, the lock is enabled;
- If both flashes are equally long, the lock is disabled.
- 38 -
CHECKING THE 2nd LEARNING LOCK
(only for special BB2BK versions or with BUPC)
- Press the key on the receiver a while and wait for 2 flashes to indicate elapsed time
!
(approx. 5 sec.);
- Press the key during the 2nd flash and release it as soon as the LED switches off.
Two flashes will follow and the 2nd should last longer than the first to indicate that the lock is enabled.
If this does not occur, repeat the entire operation from scratch.
DISABLING THE 2nd LEARNING LOCK (only for special BB2BK or with BUPC)
In order to disable the learning lock, a previously authorized remote control is required.
The operation are timed and you thus need to read all instruction before carring out the operation in
sequence:
- Press the receiver key a while, the LED lights up for 5 sec., before this time elapses you
! need to:
- Send the code until the LED switches off, by pressing any key on the transmitter.
Release the transmitter key and wait 1 sec.
- Send the code to confirm by pressing any key on the transmitter.
The LED will now flashes 4 times to indicate that the code is already inclued in the list.
- 39 -
GB