Nice BIO Serie Anleitungsheft Seite 13

"BIO" SERIES QUARTZ RADIO CONTROL INDIVIDUAL SELF-LEARNING CODE
DESCRIPTION
The "BIO" individual code system is made up of:
- 1, 2 or 4 channel transmitters (BT1K, BT2K, BT4K)
- Receivers with 1 or 2 channel terminal connections (BX1K, BX2K, BXB2K) and special 2 channel
version (BB2BK)
- Receivers with 1 or 2 channel coupling connections (BXIK, BXI2K).
- Memory card for 60 or 250 codes (BM60 or BM250)
- Charged antenna (ABK - ABKIT)
The special version receivers are
equipped with a working program
(softuare) with additional functions.
(See the instructions).
INSTALLATION
TRANSMITTERS :
The transmitters do not require any
setup. They are immediately
operational, each with its own
individual factory pre-set code.
Fig. 1
- 24 -
To check proper operation, just press any key and make sure the red transmission LED
indicator is flashing.
RECEIVERS WITH TERMINALS :
The receivers with terminals can be used universally. The container can be attached with screws
or with a bottom sticker and provides the circuit with essential and effective protection.
Connect it as per the following diagram:
Fig. 2
1-2: POWER SUPPLY
12 to 24 V DC or AC with
automatic internal regulation
BX1K 1 CHANNEL
3-4: 1st RELAY OUTPUT
BX2K 2 CHANNELS
Clean contact of normally
BXB2K 2 CHANNELS
open relay
IP53
BB2BK 2 SPECIAL 5-6: 2nd RELAY OUTPUT
CHANNEL VERSION
Clean contact of normally
IP53
open relay (only for twin
channel receivers)
1-2: ANTENNA
Antenna signal input
- 25 -
GB