Nice BIO Serie Anleitungsheft Seite 18

Fig. 10
ENTERING A CODE
This operation lets you add the code of a new transmitter into the receiver's memory.
The operations are timed and you thus need to read all the instructions to perform the operation in
sequence without stopping.
Fig. 10
- 34 -
- Press the key on the receiver for a moment to switch on the LED for 5 sec.
In this time you have to:
!
- Send a code until the LED is switched off by pressing any button on the transmitter.
- Release the transmitter key and wait 1 sec.
- Press any button on the transmitter to send the code for confirmation.
The LED will flash three times to indicate that the operation has been successfully completed. If this does
not occur, repeat the entire operation from scratch. To enter a new code, repeat the whole operation.
REMOTE CODE INPUT
To insert the code of a new remote control without pressing the receiver key, you need to have the
previously authorized remote control (consequently the first remote control code is always entered by
pressing the receiver key). All the instructions should be read to perform the operations in sequence
without stopping. Now with the remote control whose code is to be entered called NEW and the previously
authorized one called OLD, stand within the radio control's operating range and then:
- 35 -
GB