Kathrein UFSconnect 926 Kurzanleitung Seite 38

Explanation of Symbols and Signal Words
NOTICE
Material damage due to:
Incorrect supply voltage!
► Operate the unit only at the specified mains voltage. It is stated at the
back of the unit or on the external power supply unit.
Incorrectly earthed antenna system!
► Earth the antenna system in accordance with regulations or connect an
equipotential bonding conductor.
► Comply with EN 60728/11 and, where applicable, with national regula-
tions.
Overheating!
► Do not cover or block the ventilation slots and the fan of the unit by, for
example, other equipment, magazines, table cloths, clothing or curtains.
► Do not place any objects on top of the unit.
► Do not place naked flames on top of the unit, e.g. candles.
► Do not expose the unit to direct sunlight.
Long periods of absence or storms!
► If you are going to be absent for a long time or if there is a storm, always
switch off the receiver by pressing the ON/OFF switch.
► Pull the plug out of the mains socket to completely disconnect the unit
from the mains.
► Disconnect other devices connected with the unit from the mains.
Incorrect connections!
► Connect the unit as it is described in the enclosed instructions for use.
NOTICE
Loss of data and software corruption due to the receiver being discon-
nected from the mains whilst in use!
► Always switch the receiver into stand-by mode by pressing the standby
button (ON/OFF button) on the remote control before disconnecting it
from the mains.
➯ Altered and new data are saved.
6 of 32