Kathrein UFSconnect 926 Kurzanleitung Seite 60

Troubleshooting
The Receiver Is Not Responding to the Remote Control
Possible causes
The batteries of the remote control are ...
flat,
of the wrong type,
have been inserted the wrong way round.
Receiver or remote control command set
may have been unintentionally changed
The Message No or Poor Signal! Is Displayed
Possible causes
● The satellite antenna (satellite code)
is wrongly aligned and the antenna
signal is too weak
● The antenna cable is incorrectly con-
nected or damaged
● The tuner is incorrectly configured
The Wrong Time Is Displayed
Possible causes
The time changeover to summer time was
performed incorrectly.
The wrong time was taken from the
reception signal
Examples: Das Erste HD (Germany), Nederland 1 HD (Netherlands), Rai 1 HD (Italy).
1)
28 of 32
Remedy
The batteries must be ...
replaced,
replaced,
inserted correctly; see Fig. 4, P. 14.
Set the Code 1 remote control code at
the receiver and remote control; see the
instructions for use.
Remedy
Call an antenna specialist
Remedy
Check the local time zone offset (UTC)
and correct it, if necessary, (Main Menu ▶
Basic Settings ▶ Date and Time).
1. In live mode, select a transmitter
which transmits the time and date
2. First use the remote control to switch
the receiver off, then switch it off at
the mains.
3. Wait 10s then switch the receiver on.
.
1)