Maintenance; Demolition And Disposal - Berkel HOME LINE SERIES Gebrauchsanleitung

moved.
WARNING!
Use protective gloves when
the blade.
the surface of the blade and
blade cover side and the oppo-
1) replace the blade cover
blade cover 90° clockwise
until it locks into its initial
lift the meat table and move
clicks.

MAINTENANCE

Blade maintenance
keep it sharp and functional.
Do not wash the blade in the
dishwasher.
SERVICE
No replacement parts are sup-
plied in the package. All repair
and replacement
(such as replacement or repair
holder is completely re-
!
sharp, cutting hazard!
cleaning sharpening areas, the
table, the product holder and
Clean the:
- lblade: press a damp cloth on
move it slowly from the centre
toward the outside, as shown
in the figure (Fig. D), on the
site side. In the same way, dry it
using a dry cloth;
- machine body: clean the ma-
chine body with a damp cloth
or a sponge, rinsing with water.
Dry carefully.
Finally, assemble the:
- blade cover:
as in the figure; 2) rotate the
position (Fig. E);
- meat table:
it to the cutting position,
pressing down lightly until it
Cleanse the blade regularly to
of the blade, belt, electrical
Blade is manufacturer.
visable to return the machine
to the manufacturer or to an
Authorised Service Centre.
service@berkelinternational.
com.
mm.
WARRANTY
AND RESPONSIBILITY
The manufacturer provides
24 months starting from the
date of purchase. The warran-
the conditions of use provided
does not cover defects due
improper installation or place-
voltage greater than 10% of
except in the case of obvious
production defects.
direct and indirect responsibil-
- failure to observe the instruc-
activities tions in this manual;
- use which does not conform
components, structural parts,
etc.) must be carried out solely
by persons authorised by the
If a repair is required, it is ad-
For information about services
centres, contact:
WARNING!
!
must be replaced when the
distance between the edge of
the blade itself and the internal
edge of the protection exceeds 5
machines with a warranty of
ty covers only those defects if
used properly and according to
by the manual. The warranty
to transport, the purchaser's
incompetence or negligence,
ment, damage due to wear, or
the nominal value. Further-
more, the warranty does not
cover components inherently
subject to wear, such as the
blade and sharpener wheels,
The manufacturer declines any
ity stemming from:
to regulations in the country of
14
The blade
installation;
- unauthorised modifications
and/or repairs on the machine;
- use of non original accesso-
ries or replacement parts;
- exceptional event.
The transfer of machine own-
ership involves the immediate
exception of compliance with
of the product).
base of the machine registers
and the CE marking.
DEMOLITION
AND DISPOSAL
- inserts and various compo-
nents in stainless steel;
- electrical parts and electrical
cables;
- electric motor;
If disposal is entrusted to a
thorised companies for dispos-
al of the materials mentioned
above. The device contains ma-
terials which can be recovered
lection point. Information on
disposal can be obtained from
local authorities.
release from any responsibility
by the manufacturer, with the
Directive 2006/42/EC (liability
for any manufacturing defect
The identification plate at the
the manufacturer, the ma-
chine, technical information
The machine is composed of:
- aluminium alloy;
- plastic, etc.
third party, contact only au-
or recycled. Proper separate
collection facilitates recycling.
At the end of machine life, de-
posit in your device at a col-