Flush Cutting - Husqvarna WS 462 Bedienungsanweisung

4 Hang the blade with the blade flange and blade flange hub
fitted on the cutting arm (blade is not shown in the figure).
• Turn the blade flange hub carefully so that it slides into
one of the tracks in the pivot arm and lands in the correct
position to be screwed fast.
5 Press in the blade spindle into the cutting arm at the same
time as the blade is rotated carefully. When the blade
spindle can no longer be pressed in by hand it should be
tightened using the supplied 18-spanner until it is properly
secured (tightening torque 70-80 Nm).
WARNING! Exercise care when assembling
!
the blade so that it does not risk becoming
loose when cutting. Carelessness can result
in serious personal injury or even death.
ASSEMBLY

Flush cutting

Screw off the outer blade flange and mount the blade on the
blade flange hub.
A=110 mm/4.33 inch, 6xM10
B=89 mm/3.5 inch, 6xM8
C=144 mm/5.7 inch
– 11
English