Rear Panel - Omnitronic CMP-430 Bedienungsanleitung

11. PITCH BEND-BUTTONS
With the Pitch Bend-buttons, you can adjust the playback-speed temporarily by up to +/-16 %. Please refer
to 6.6 Adjusting the playback-speed.
12. PITCH-BUTTON
(1) With this button, you can switch the speed-adjustment via the Pitchfader on and off. Please refer to 6.6
Adjusting the playback-speed.
(2) Press and hold the Pitch-button for one second in order to adjust the speed-adjusting range between
±8 %, ±12 % or ± 16 %.
13. PITCHFADER
You can adjust the desired speed with the Pitchfader after pressing the Pitch-button. The display shows the
current percentage. If the Pitch-button is not pressed, any adjustment on the Pitchfader will have no effect.
14. TIME-BUTTON
The display can be switched from track remain time (Remain) to track playback time (Elapsed). During
playback of a track or a program, the display shows the track remain time (Remain). Press this button once
and the display shows the track playback time (Elapsed).
15. SGL-BUTTON
For choosing single playback or continuous play. The indication "SINGLE" means that the CD-player is in
Single-mode. The current track is then played once and the player goes into pause mode at the beginning of
the next track. By pressing the SGL-button again, the CD-player changes back to normal playback mode i.e.
after the current track is played, the player remains in playback-mode.
16. PROGRAM-BUTTON
With the Program-button, up to 20 tracks can be programmed.

4.3 Rear panel

17. AC CONNECTION
Plug in the power supply cable here.
18. VOLTAGE SELECTOR
Make sure that the indication corresponds to the available voltage.
19. AUDIO OUT-SOCKETS
The music-signal of these sockets is analog. Connect the output to the respective input of your mixer.
20. DIGITAL OUT-SOCKET
The music-signal of this socket is digital. Connect the output to the respective input of a digital amplifier for
example.
20/46 10602415_V_1_0.DOC