Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ASSEMBLING AND ADJUSTMENTS
Connect the power unit
•
The couplings should be wiped clean to reduce the risk of
leakage before the hoses are fitted.
•
The couplings are locked by turning the outer sleeve on
the female coupling so that the slot moves away from the
ball.
Connect the water cooling
•
Connect the water hose to the incoming water connector.
Fitting the drill bit
•
Apply water-resistant grease to the thread of the drill bit.
•
Attach the drill bit using the open-ended spanners.
•
Before the machine is started, carefully check that the new
bit is firmly attached.
Speed
•
Set the right speed for the present diameter of the drill bit.
See instructions in the section "Technical data".
•
The hydraulic motor speed can be set in three positions.
The motor speed can be changed during operation.
•
The mechanical gearbox has two gears.
NOTICE! Changing mechanical gear may only be done
when the machine is switched off. Otherwise there is a risk
of damaging the gearbox.
– 9
English
Werbung
Kapitel
Inhaltsverzeichnis
