Team Electronic CB Mobile MiniCom Bedienungsanleitung Seite 10

Transmitting
To transmit, press and hold the PTT key at the microphone. The TX
symbol appears in the LCD.
For best quality, speak normally at a distance of 2 - 4 inches. Speaking too
loudly will cause distortion and makes the signal difficult to understand.
While the set is in the transmit mode there is no key entry possible and
the receiver is muted.
On completion of the transmission release the PTT key and the radio
will switch back to receiving mode.
Priority Channel 9 / 19 [EMG]
To switch to priority channel 9 press the EMG key (4) once. To quickly
get to priority channel 19 press the EMG key (4) twice. And to return
to the originally selected channel, press the EMG key one more time.
Key lock [EMG]
Pressing the EMG key for approximately 1 second will activate/de-
activate the key lock. The symbol LC will be displayed shortly. Except
for the PTT key and the combined volume and on/off control, all ele-
ments are blocked.
Receipt-Signal Sensitivity [RFG]
Signals received from immediate proximity may be too strong, they will
be received distorted.
With the RFG control [RFG] (3), the strength of the received signal
will be diminished by reducing the receivers sensitivity. In active RFG
mode the letter R is displayed.
After pressing the RFG key (3), the actual value is displayed, i.e.
6/12/18/24/30/36/42/48/54 dBm. During this short period the value can
be changed with the channel selector key UP and DN at the microphone.
External speaker jack
The CB Mobile MIniCom is equipped with a 3.5 mm socket (7) at the
rear panel to connect an external speaker of 4 - 8 ohm impedance,
e.g. TEAM TS-500. At 4 ohms the speaker load can be 4 watts. When
the external speaker is connected, the internal speaker will be
switched off.
18
Additional information
Safety instruction
Drivers must obey traffic rules regarding the use of transceivers in a
vehicle. The unit radiates RF energy in transmit mode. Please keep
an eye on safety distance to the antenna.
General precautions
Protect the mobile radio from humidity and dust. Do not store at
places where the temperature may rise and cause damage, for ex-
ample in the sun. The radio can be cleaned by wiping with a soft cloth.
Do not use chemical products for cleaning.
Servicing
The device must not be opened. Independent repairs or adjustment
must not be carried out, since each modification or unauthorized in-
tervention will result in withdrawal of the operation permit and of war-
ranty and repair claims. Do not use the mobile radio if it seems not to
function correctly. Disconnect the radio from the DC power source
immediately. If there is a defect, the authorized TEAM specialist
dealer or TEAM must be contacted immediately.
Conformity
The CB mobile transceiver TEAM CB Mobile MiniCom complies to the
European directive R&TTE and meets the European standards EN 300
135-1/-2, EN 300 433-2, EN 301 489-1/-13 and EN 60950-1.
The specific regulations of the different versions in the different euro-
pean countries can be found in the radio passport that is included in
this manual.
- specifications are subject to change without any prior notice -
19