Troubleshooting - Klarstein 10032914 Bedienungsanleitung

TROUBLESHOOTING

Problem
Dishwasher doesn't
start.
Water not pumped
from dishwasher.
Suds in the tub.
Stained tub interior.
White film on inside
surface.
There are rust stains
on cutlery.
Possible Causes
Fuse blown, or the circuit
breaker tripped.
Power supply is not turned on.
Door of dishwasher not
properly closed.
Kink in drain hose.
Filter clogged.
Kitchen sink clogged.
Improper detergent
Spilled rinse-aid
Detergent with colourant was
used.
Hard water minerals.
The affected items are not cor-
rosion resistant.
A programme was not run after
dishwasher salt was added.
Traces of salt have got into the
wash cycle.
The lid of softer is loose.
What to do
Replace fuse or reset circuit breaker. Remove any
other appliances sharing the same circuit with the
dishwasher.
Make sure the dishwasher is turned on and the
door is closed securely. Make sure the power cord is
properly plugged into the wall socket.
Closed dishwasher making sure that door latches.
Check drain hose.
Check coarse filter.
Check kitchen sink to make sure it is draining well.
If problem is kitchen sink not draining ,you may
need a plumber rather than a serviceman for dish-
washer.
Use only the special dishwasher detergent to avoid
suds. If this occurs, open the dishwasher and let
suds evaporate. Add 1 gallon of cold water to the
tub. Close and latch the dishwasher, then Start any
wash cycle to drain out the water . Repeat if neces-
sary.
Always wipe up rinse-aid spills immediately.
Make sure that the detergent is the one without
colourant.
To clean the interior, use a damp sponge with dish-
washer detergent and wear rubber gloves. Never
use any other cleaner than dishwasher detergent
for the risk of foaming or suds.
Don't wash corrosive items in the dishwasher.
Always run the Quick wash programme, without
any crockery in the dishwasher and without se-
lecting the Turbo function (if present), after adding
dishwasher salt.
Check the lip .Ensure the fix is fine.
49