AXTON A100 Bedienungsanleitung Seite 5

1. CONNECTIONS + CONTROLS A500 - PAGE I
1 SIGNAL INPUTS FRONT R / L and REAR R / L
Front and Rear channel Low-level stereo RCA signal or high-level speaker signal input
terminals for connection to head-unit.
2 INPUT GAIN CONTROL FRONT CHANNELS
Input gain potentiometer for channel FL/FR-CH, to match the output voltage of the head
unit to the amplifier's input.
3 OPERATION MODE SWITCH FRONT CHANNELS
Slide switch to select the operation mode of the X-over for section FL/FR-CH of the
amplifier: 50 Hz Highpass or full signal.
4 BASS LEVEL REMOTE CONTROL INPUT
Input terminal to connect the external bass level remote to the amplifier.
5 INPUT SIGNAL SELECTION
Slide switch to select the input signal for all channels. "2-CH" to use only front input
terminal for all output channels. "5-CH" to give each output channel its corresponding
input channel (the CH 5 is summarized by all 4 input channels).
6 OPERATION MODE SWITCH REAR CHANNELS
Slide switch to select the operation mode of the X-over for section RL/RR-CH of the
amplifier: 50 Hz Highpass or full signal.
7 INPUT GAIN CONTROL REAR CHANNELS
Input gain potentiometer for channel RL/RR-CH, to match the output voltage of the head
unit to the amplifier's input.
8 POWER LED
LED to show the operating status of the amplifier by blue/red illumination. Blue is
normal working state, red is protect mode of amplifier.
9 AUTO-TURN-ON MODE
Slide switch to select the auto-turn-on function: REM by remote wire, VOX to switch on
by music signal or DC by DC offset signal of the head units integrated amplifier.
10 LOWPASS FREQUENCY CONTROL SUBWOOFER CHANNEL
Control potentiometer to adjust the lowpass filtering frequency point of the subwoofer
output channel.
11 INPUT GAIN CONTROL SUBWOOFER CHANNEL
Input gain potentiometer for subwoofer channel, to match the output voltage of the head
unit to the amplifier's input.
12 INPUT MODE SELECTION
Switch to select the proper input sensitivity range: RCA signal input = Low. Speaker
signal input = Hi.
13 SPEAKER OUTPUT TERMINAL
Output terminal to connect the speakers to the amplifier in either stereo or bridged
mode.
– 8 –
1. CONNECTIONS + CONTROLS A500 - PAGE II
14 "+12 V" POWER INPUT TERMINAL
Terminal to connect the amplifier to the positive +12V pole of the car battery.
15 "REM" INPUT TERMINAL
Terminal to connect the amplifier to the automatic (remote) turn-on / turn-off lead of the
head unit. You must switch 9 to "REM" when using the remote wire input terminal.
16 "GND" POWER INPUT TERMINAL
Terminal to connect the amplifier to the chassis ground or negative pole of the car
battery.
1 2 3
Auto Turn On
4 5 6
105.0 mm
9 bl bm
bo bp bq
– 9 –
7 8
bn 1
br