Axkid Move Bedienungsanleitung Seite 17

Fastening the vehicle seat belt
Open the belt lock-off clips (M) on both sides of the Move child restraint. Fully lengthen the seat
18
belt until the lap section of the belt is at least 70-80cm (27-32 inches) long. Feed the seat belt
through the seat belt slot (D), between the seat cover and seat body until the belt comes out
through the seat belt slot on the other side. If you prefer, you can instead feed the seat belt through the
seat belt slot (D), then over the top of the seat cover and then through the seat belt slot on the other
side.
Insert the seat belt tongue into the vehicle' s seat belt buckle. Pull the seat belt until all slack is
19
removed along the seat belt route. Secure both the lap and shoulder belt in the lock-off closest
to the vehicle' s seat belt buckle.
20
In the lock-off on the opposite side, only the lap belt should be secured.
Attaching the tether straps
Unclip the tether straps from the child restraint.
21
Press the grey button (N) and pull the loop end out to maximise the length of the strap.
22
To attach the tether straps to an anchor point, wrap the strap around the chosen anchor point
23
and pass the metal clip through the loop.
When installing the Move on a back seat, wrap the tether straps through either the rear of the
24
front seat rails (i), or the hinge of the front seat (ii).
When installing the Move in the front passenger seat, the tether straps should be wrapped
25
around the nearest suitable anchor point (i) that will allow the straps to be tightened fully.
Anchor points set further back (ii) can be used and if need be the straps can be crossed over
(iii) and even looped together (iv).
Reattach the metal clips to each side of the child restraint and pull the free ends of both tether
26
straps until you have tensioned them. Pull each strap once again as hard as possible to ensure
the child restraint is secured tightly.
Unfold the support leg (Q) out to its maximum angle. Press the leg extension button (R) and extend the
27
support leg until it reaches the floor.
Note: The support leg belt may, but does not need, to be fully tensioned.
It is important that you check that the support leg is at an angle over 10° from the back of the
28
seat. You could check this by ensuring that the support leg is further away from the seat than
the vertical line.
7