Axkid Move Bedienungsanleitung Seite 15

Allowed and disallowed positioning of the child car seat.
Front passenger seat (no active airbag)
Front passenger seat (active airbag)
Forward facing seat with 3-point seat belt
Seat with 2-point seat belt
Side facing seats
Rear facing seats
Never use this child seat in a car that is not equipped with an
ECE Reg 16 approved three-point belt.
Rear-facing 9-25 kg with seat belt & tethers
Adjusting the headrest and harness height
Before you install the child restraint make sure that the headrest is at the correct height for your
2
child. The harness, when correctly installed, should be routed from the back of the seat to the
front and pass just above your child' s shoulders.
In order to adjust the height of the headrest and harness you will first need to detach the
3
harness. Press the harness adjuster button (E) and pull forward on the shoulder straps (not the
shoulder pads) to completely loosen the harness.
4
Open the zipper (P) on the back of the seat cover.
5
Unhook the shoulder straps from the yoke (S) at the back of the child restraint.
Unfasten the Velcro® and detach the shoulder pads (B) on the back of the seat.
6
Pull the shoulder pad straps and shoulder straps out from the seat.
7
Squeeze the plastic clip and gently pull the headrest free from the seat.
8
Reposition the headrest at one of the three heights that best suits your child. Push the bottom
9
of the headrest until the plastic clip locks in place.
5
Yes
NO
Yes
NO
NO
NO