Noise/Vibration Information; Declaration Of Conformity; Mounting And Operation - Bosch GHP 5-14 Originalbetriebsanleitung

OBJ_BUCH-1762-001.book Page 12 Thursday, August 16, 2012 10:03 AM
12 | English

Noise/Vibration Information

Measured sound values determined according to 2000/14/EC (1.60 m height, 1 m dis-
tance away).
Typically the A-weighted noise levels of the product are:
Sound pressure level
Sound power level
Uncertainty K
Wear hearing protection!
Vibration total values (triax vector sum) determined according to EN 60335:
Vibration emission value a
h
Uncertainty K

Declaration of Conformity

We declare under our sole responsibility that the product described under "Technical data"
is in conformity with the following standards or standardization documents: EN 60335 ac-
cording to the provisions of the directives 2011/65/EU, 2004/108/EG, 2006/42/EG,
2000/14/EG.
2000/14/EC: Guaranteed sound power level
Conformity assessment procedure according to Annex V.
Equipment category: 27
Technical file (2006/42/EC, 2000/14/EC) at:
Bosch Lawn and Garden Ltd., PT-LG/ENS,
Stowmarket, Suffolk IP14 1EY, England
Dr. Egbert Schneider Helmut Heinzelmann
Senior Vice President Head of Product Certification
Engineering PT/ETM9
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
29.06.2012

Mounting and Operation

Action
Delivery Scope
Handle Assembly
Filling up detergent tank
Water connection
Cleaning the Filter
Connecting high pressure water supply hose/
nozzle
Adjust water pressure
Adjust water jet
Switching on and off
Clean nozzle
F 016 L72 355 | (16.8.12)
Starting
For Your Safety
Warning! Switch off, remove plug from mains be-
fore adjusting, cleaning or if cable is cut, dam-
aged or entangled.
Your pressure washer requires an earth connection. The op-
erating voltage is 230 V AC, 50 Hz (for non-EU countries
220 V, 240 V as applicable). Only use approved extension ca-
bles. Contact your Bosch Service Centre for details.
If you want to use an extension cable when operating your
high pressure washer, only the following cable dimensions
should be used:
2
– 2.5 mm – max length 20 m
2
– 4.0 mm – max length 50 m
Figure
Note: If an extension cable is used it must be earthed and con-
nected through the plug to the earth cable of your supply net-
1
work in accordance with prescribed safety regulations.
2
If in doubt contact a qualified electrician or the nearest Bosch
3
Service Centre.
4
WARNING! Inadequate extension cables can be
5
dangerous. Extension cable, plug and socket
must be of watertight construction and intended
6
for outdoor use.
7
Cable connections should be kept dry and off the ground.
8
For increased electrical safety to use a Residual Current De-
vice (RCD) with a tripping current of not more than 30 mA. Al-
9
ways check your RCD every time you use it.
10
If the supply cord is damaged, it must be replaced by a Bosch
Service Centre.
Products sold in GB only: Your product is fitted with an
BS 1363/A approved electric plug with internal fuse (ASTA
approved to BS 1362).
3 600 ... J 10 1.. J10 2..
dB(A) 84.5 82.5
dB(A) 92 90
dB =3 =3
2
m/s =4.91 =4.91
2
m/s =1.5 =1.5
3 600 ... J 10 1.. J10 2..
dB(A) 92 90
Bosch Power Tools